Does it have TPMS option in there

 

Sorry just seen that 101 line

 

Also does focus have power tailgate option

 

Do you just choose without tpms
what program is better forscan or foccus or easier to use?
i dont like the blocks of numbers you have to change

 

Do you just choose without tpms

Yes. It's a simple selection on FoCCCus. I'm not sure what is available with ForScan as I haven't looked recently with the extended licence activated.

They will both do the job, Forscan is more stable.

If you're using an OBDLink interface FoCCCus is also very stable and there shouldn't be any problems. It's the modified ELM327 devices that usually have the issues with FoCCCus loading/ writing.

 

They will both do the job, Forscan is more stable. There’s lots of reports of things going wrong when using Focccus. The choice is yours but if it was me I would use Forscan.

 

What line is for Disabling on Foccus the obdlink turned up today
got me smart charger on so batt fully charged and i will keep it on during
pic of my charger below is it sufficient....?

 

got me smart charger on so batt fully charged and i will keep it on during
pic of my charger below is it sufficient....?

Better than nothing- it's only a 3.8A charger. Just keep an eye on the battery voltage and turn off anything unnecessary (HVAC/ Audio, check the seat heaters are off etc.) while using FoCCCus/ ForScan.

 

Why cant it be easy like this:
2016 Ford F150 XL FX4 - Forscan - Deleting TPMS - YouTube

 

It is. Shouldn't be any different on yours.

If you use foccccus it is as your post #35 lol.

 

prob is just trying to juggle this and the power liftgate at once

 

One step at a time lol......

 

Remember.......back up.

Go to configuration. That's the one that looks like a chip (computer chip)
Click on the module your going to change.
Press play
Press save all
Make sure the file goes where you will find it. Create one if necessary.

 

With FoCCCus line 101 change to 01 to disable TPMS. That's what mine is set to with no TPMS sensor fitted from the factory. Yours will most likely be set to 06 according to some old data I kept from a UK Kuga.

 

Cheers all above got rid of that poxy TPMS good riddens....

 

At last lol.

 

Thanks. My TPMS sensor died aswell, and the error does get quite annoying

 

And when you take it for an MOT and the tester finds that the TPMS has been disabled (they do check) the car is an instant failure.

 

I never seen them plug anything into the obd2 port

 

When you turn on the vehicles ignition the light should show for a few seconds and then go out once the vehicle has checked for problems. If the tester noticed no light on when first turning on the ignition then they would/shud put it down as an advisory at least or possible fail for safety reasons depending on the tester.

 

IIRC the valve stems are another clue that car has TPMS fitted , as they have a circular ridge around them