Ford Kuga Owners Club Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,007 Posts
Discussion Starter #1
Jacked the car up today to replace both rear discs and after removing the caliper I am amazed to see two puny looking Torx headed bolts holding the caliper bracket on. Normally these are something like a 14/15mm hexagon head fitting.

Does anyone know what size Torx socket i need for these. I think it's possibly an E12.

I have had a look on here but after best part of an hour the only reference I could find was an owner who had the normal bolts fitted with a 15mm hexagon head.

Hopefully someone will tell me that a bolt fitted with something the size of a 10mm torx head is going to be a lot stronger than one with a 15mm hexagon head.
 
1 - 1 of 1 Posts
Top