Ford Kuga Owners Club Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
138 Posts
Discussion Starter #1
Hi,


After at last getting some sun to warm the door panels thoroughly so the adhesive strips would adhere firmly, I've finally fitted the mouldings. The doors have already taken a couple of hits from Mr & Mrs thoughtless so they are already proving worth the cost - about £60 through a firm down South. (vanstyle.co.uk)



Here's the link. http://www.flickr.com/photos/heli_mad



Comments welcome but personally I think they're ok. doh!!!



Only issue is to get the right start and end point plus same heights both sides measured from door handles. Thankfully the mouldings when fitted properly present a dead straight upper edge so it's actually quite easy to get it right.



Driven 1000 miles since Friday to Cheshire and home again and they haven't shifted a bit.



Regards

PJ
 

·
Registered
Joined
·
101 Posts
Not to my taste, dosen't quite fit with the Kugas Kinetic design.
Though they do say prevention is better than cure!


Edited by: Kugameister
 
1 - 3 of 3 Posts
Top