Ford Kuga Owners Club Forums banner

error code

2K views 3 replies 2 participants last post by  NigelB 
#1 ·
hi all, new to the forum.
Have recently purchased a kuga, 2017 zetec ex police.
It has done 116000 miles and am now getting an error code P2033.
Exhaust gas temp sensor circuit high bank 1 sensor 2.
where is this located, is it easy to change and finally is it expensive.
Have read quite a few threads on dpf faults but not seen this code mentioned before.
Any advice welcome
Thanks in advance
 
#2 ·
It's fitted just after the DPF under the car.

If you are lucky it will just be a dodgy connector or rubbed wire.

Failing which, it is plug and play (12mm spanner needed) but the cable is a bit of a bugger as it has to be fed back up into the engine bay and the part is just shy of £200.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top