Drivers Seat | Ford Kuga Owners Club Forums

1 - 1 of 1 Posts

steve1953

·

Registered

Joined Dec 29, 2008

·

12 Posts

Discussion Starter • #1 • Mar 25, 2009

I have a Panther Black Zetec Kuga, i have covered 2100 miles. After about 400 miles i noticed the drivers seat had a crease on the side of the base of the seat which did not come out of the material when the seat wasn`t being sat on.
Now at 2100 miles the seat has 3 creases in the side of the base of the seat, my dealer hasn`t got another Kuga to compare mine to has anyone else got the same problem.

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

Auto headlights not working

Mk1 Technical

Newbie to the site. Please help I have a mk1 on a 10 plate, I have an issue with the auto headlights when I put them on auto they stay on permanently is there a fuse or relay that could be causing this fault if so where would it be located. Many thanks in advance
- 17
- 643
- R
  Raj35h · updated 2 days ago
Passenger side flooded

Mk1 Technical

Hi All, The passenger side foot well is absolutely saturated. Currently i have lifted most of the carpet and insulation and there is loads of water. Has anyone came across this before? I can't seem to find where or how the water is getting in. It seems to be coming higher up under the glove box...
- 10
- 230
- Rabb1t · updated 2 days ago
Throttle body seal

Mk1 Technical

Hi, I have an 09 MK1. I have discovered that my throttle body does not mate fully with the intake manifold, causing the engine to judder at 2k revs and high load (air/fuel mix off) I have taken the TB off and the checked the housing (100% intact), the seal ring is solid and I surmised that...
- 5
- 238
- K
  Kuga-Craig · updated 3 days ago
2009 kuga 2.0 tdci awd vibration .

Mk1 Technical

Hi I purchased a 2009 kuga 2.0 tdci awd 3 months ago and it has developed a vibration/shudder under hard acceleration in 6th gear between 60-70 mph it doesnt do it if you accelerate gently. I can only describe it as the same sort if noise as if you are driving over rumble strips on the motorway...
- 14
- 230
- V
  Vailer15 · updated 3 days ago
Engine malfunction / traction control fault

Mk1 Technical

Hi I have a 2010 2wd 2.0 titanium, The traction control light flashes and engine malfunction light comes on pings and goes into get you home mode, Once you stop the engine and restartitresets itself and then its ok until it does it again, there is no pattern to when this happens high speed, low...
- 8
- 2K
- N
  nipper.1 · updated 3 days ago

Join now to ask and comment!

Top