Info on factory fit & reto fit parking sensors

Haven't done it yet but now I know which is the reversing wire I will give it a go and post some pictures. I've had a god look and you don't need to remove bumper, it's easy to tape the sensor on from under the car.  Convenient grommet to pass wire through and access to wire loom easy. Just need advice on best way to connect wire reversing light wire?

i'm thinking of buying the same kit,  is it easy to install.  How have you all connected to the reverse wire?

Picked up my new Kuga on Saturday.

Hi Morph, I have front/rear colour coded sensors, even before the car was washed (just once so far) paint started to disappear (driving rain?) from a few of the sensors. I contacted dealer, Response. "you will have to book car into bodyshop, may be there for a few days?"  so I ordered a two pack paint/lacquer pen set, and did it myself. Just before I proceeded, on close inspection looks like it was covered in just Avalon base coat, the lacquer was missing?  but if paint falls of again may just water jet blast them down to the base colour, which is black.   Bob.

What are people's opions of these now that you have had them in use for a while? Was thinking of fitting ultra sonic sensors, but not really keen on drilling my new bumper.